Custom Power Amplifiers

VT3 High voltage amplifier for driving piezo stack

The VT3 model shown below is custom made to drive piezo stacks of 40uF with 200V square waves.
This amplifier can drive a 40uF load with 200V square wave at 120Hz.
Rise/fall time is 400uS for a 200V step and 40uF load (2 V/uS).
The charging current is 20A.
Output is protected for short circuits, so if the stack shorts out the amplifier just shuts down.
Amplifier also protected agains overtemperature.
Monitor outputs for output current and output voltage.

Inside view of the VT3:

Dimensions of the VT3 is 17"wide, 3.5" high and 12" deep.
Rack mount adapter available.
We can also make similar amplifiers for lower/higher voltage and current.