LN106 Phono Preamp

Precise RIAA correction.
8Hz subsonic filter.
MM 40dB gain
Low noise: 82 dB SNR.
Small size.

The LN106 solid state phono preamp  provides precision amplification and RIAA correction for MM cartridges. Standard input load is 47K and 120pF; others are available. A 8Hz subsonic filter suppresses all frequencies below 8 Hz while keeping the in band sound signals unaffected.
The subsonic filter greatly reduces unwanted cone movements due to record warp, etc.
Power is provided using a 24VDC wall adapter. This is a cost effective way to provide power while eliminating powerline hum.
We use the highest quality op-amps, 1% metal film resistors and 2% polypropylene capacitors for superior sound.
The LN106 can be used "stand alone" or can be built into the base of the turntable or into existing preamps.

For a review of the LN106 and LN108 in UHF magazine issue 73 click here.; go to page 35

Inputs: 1 pair of heavy duty gold RCA connectors.
Output: 1 pair of heavy duty gold RCA connectors.
Grounding: Binding post near input connectors.
Power: 2.5mm power jack for 24VDC wall xformer.

Frequency response: 20Hz - 20KHz +/- 0.1dB
Input impedance: 47 KOhm + 120pF
Output Impedance: 50 Ohm.
Gain: 40dB @ 1KHz.
Signal to noise ratio: 82dB ref. 5mV input@1KHz, A weighted
Equ. input noise voltage: 0.038uVRMS, A weighted
Output load: any.
Max. output voltage: 7 VRMS.
Dimensions: 1" x 2" x 4"

Ordering Information:
LN106-AA Phono Preamp